Gate Valve
Posted by AdminFire on February 21st, 2007
Prevent leakage at the bottom of your Water Heater: Update Your Drain Valve
Author: John Haynes
Many water heaters come with a drain valve that has a cone-shaped handle. They spell trouble. Other manufacturers of water heaters faucet has a type of plastic drain valve. This type of drain valve is prone to breaks and leaks. The best types are the brass hose BIBB, not unlike BIBB the average garden hose. Even better would be Brass Ball valve. This type of drain valve would have a lever that can be open or closed. The brass ball valve allows more efficient washing of the water heater.
In most residential water heaters, 3 / 4 gate valve inch brass can be installed. Ball valves allow more open drain valves that gives the best wash the inside of the drain valve. Off a ball valve is as easy as moving the lever 90 degrees. A hose BIBB must be the return trip. We also know that a piece must be installed adapter ranging from 3 / 4 pipe thread 3 / 4 wire hose will be needed. Now you have the brass ball valve that is the least we can block all the valves drain. If the brass ball valve can not be installed, the second best is a brass hose BIBB.
Plastic valves and plastic cone dripping faucet valves, in freezing, and sediment cover with the easiest. Threads of plastic are easy to cross when you want to connect a hose garden to the drain valve. Even after opening a plastic valve once, using it and closing back up, the valve can drip. To remove the plastic cone valve, unscrew the water heater by turning it counterclockwise while pulling it out. Six laps probably will suffice. Then turn right and continue shooting. Wrap Teflon tape around the protruding nipple. Now install the brass ball valve. In order to avoid be sprayed with water while installing the new drain valve, first cut off the supply of water to the cold water inlet at the top of the heater Hot water is closed when the water stops flowing through. That'll keep any air into the lines.This relieves pressure on the lines and allow that the drain valve to be replaced without draining the water heater. Make sure no one is using water, while going to replace the drain valve. Also the pilot gas supply or pull the electrical plug, if electric.
A liter of water or less can get out of the water heater after all the preparation inside. Be prepared to begin the procedure quickly right after though.
Remember, adding a brass gate valve can be used to clean the tank and kept clean of sediment. A free tank produces hot water sediment.
About the author:
Check out href = "http://www.waterheater-info.com"> http://www.waterheater-info.com or contact johnnyhayneser@gmail.com for contact information on solar water heaters (which are the ultimate in energy efficiency), tankless water heaters (to save money on your energy bill energy), water tank heaters traditional type (they are the cheapest and easiest to install), repair the water heater and maintenance, brand information (that there is much out there and looking from one site to another is a long time) warranty information, and the installer to hire …
Article Source: ArticlesBase.com – title = "prevent leakage at the bottom of your water heater: Update the drain valve "> Preventing leaks in the bottom of your water heater: Update Your Drain Valve
|
|
Vintage Plumbing Pressure Valve? Antique Gate Ball Valve? Swastica Stamp $46.00 |
|
|
New Mueller B & K 100-010 Brass 3″ Threaded Gate Valve $50.00 |
|
|
ALL S.S. Gate Valve – 1-1/2″ $95.32 |
|
|
Stainless Steel Gate Valve 2″ SS 316 FxF $122.72 |
|
|
3/8″ TH Gate Valve by Mueller/B&K 100-202 $17.49 |
|
|
1/2″ S Gate Valve by Mueller/B&K 100-703 $17.99 |
|
|
New 1″ CXC Nibco Gate Valve NRS Stem Class 125 $10.00 |
|
|
JENKINS 2 1/2″ GATE VALVE $99.99 |
|
|
VAT GATE VALVE MONOVAT CLASSIC 0210X-BA24-BLP1/0018 $1,999.00 |
|
|
VAT GATE VALVE MONOVAT CLASSIC 0210X-BA24-AXN1/0324 $1,999.00 |
|
|
Jenkins Bronze 1/2″ Threaded Gate Valve 200 WOG 125 S FREE SHIPPING $29.00 |
|
|
Jenkins Bronze 3/4″ Gate Valve Solder Ends 200 WOG 1240 FREE SHIPPING $29.99 |
|
|
Jenkins 1″ Bronze Gate Valve Threaded Joints 200 WOG FREE SHIPPING $34.99 |
|
|
JORDAN VALVE 60HP MARK SER. SELF OPERATED SLIDING GATE PRESSURE REGULATOR 27808 $99.99 |
|
|
VELAN CLASS 800 1IN GATE VALVE CA15 MODEL A A105N 45236 $3.99 |
|
|
VAT 14046-UE24-0006/0005 HV STAINLESS STEEL GATE VALVE $2,999.99 |
|
|
VAT 14046-UE24-0006/0006 HV STAINLESS STEEL GATE VALVE $2,999.99 |
|
|
VAT 14046-UE24-AAC1/0001 HV STAINLESS STEEL GATE VALVE $2,999.99 |
|
|
R-P&C EF56D CR-13 F.S. H.F. 1″ NPT STEEL GATE VALVE NEW $40.00 |
|
|
OIC 316/L SS 3/4″ GATE VALVE 800 SERIES JIC/WELD X NPT $99.00 |
|
|
Hydrant Gate Valve/Wrench and Brass Reducer $139.99 |
|
|
Cooper 2″ Stainless Steel 150 Lb Gate Valve New $195.00 |
|
|
VELAN 1/2″ NPT S-2054B-02TY 800 STEEL GATE VALVE NEW $25.00 |
|
|
Powell Gate Valve 1.5″ Figure # 2495 SS Gate Valve New $145.00 |
|
|
HENRY VOGT 59851 1/2″ 800 GATE VALVE NEW $20.00 |
|
|
CRANE 488 GATE VALVE $75.00 |
|
|
VELAN MODEL A GATE VALVE 2IN NPT CLASS 800 S-2054B-02TY B16-34 42508 $110.00 |
|
|
10771 Stockham 300S 1-1/4″ Gate Valve $30.45 |
|
|
Varian Vacuum Research Chamber ASA 400 Gate Valve MDC $750.00 |
|
|
CRANE B-3604XU-T B-3604XU 3/4″ STEEL GATE VALVE CLASS 800 1975PSI 44278 42498 $39.15 |
|
|
1″ Sweat Brass Gate Valve by Matco-Norca $8.95 |
|
|
1″ Threaded Brass Gate Valve by Matco-Norca $8.95 |
|
|
3/4″ Threaded Brass Gate Valve by Matco-Norca $7.25 |
|
|
1/2″ Threaded Brass Gate Valve by Matco-Norca $4.95 |
|
|
1/2″ Sweat Brass Gate Valve by Matco-Norca $4.95 |
|
|
Proflo PFT400M non-rising stem gate valve 3″ IPS $175.00 |
|
|
STS System Total Sol. Manual Gate Valve Lot MGV50-D5 $253.55 |
|
|
Varian 951-5227 4″ Swing Gate Valve w/ 6″ OD Conflat Flanges $1,189.00 |
|
|
JENKINS BROS. FIG. 1324 1-1/2″ GATE VALVE NPTF 200OWG 316SS STAINLESS 44270 $69.99 |
|
|
NEWCO 1-1/4″ STAINLESS STEEL GATE VALVE CLASS 800 NPTF 316SS 44269 $49.99 |
|
|
NEWCO 1-1/4″ STAINLESS STEEL GATE VALVE CLASS 800 NPTF 316SS 44267 $119.99 |
|
|
SAN FRANCISCO FIRE DEPARTMENT-SIX INCH GATE VALVE COVER-CAST IRON-RARE $30.99 |
|
|
Lam Vat Gate Valve F12-60436/488 12044-PA44-0003 New $754.55 |
|
|
NEW NEWCO/VITAS 4″ 300 STEEL GATE VALVE 13FCB3 $980.00 |
|
|
NEW POWELL CLASS 150 GATE VALVE 1-1/4″ NPT BRASS 42502 $44.99 |
|
|
Tera Tech Tera-G/V-KH150 Gate Valve $675.00 |
|
|
Fairbanks – 0210 Fire Equipment Gate Valve $150.00 |
|
|
BRADY 103535 GATE VALVE LOCKOUT 1-2.5 INCH VLV NEW QTY1 $19.95 |
|
|
Vacuum Research High Pressure Gate Valve ISO 180 $599.99 |
|
|
Milwaukee 1150 Series Threaded Bronze Gate Valve 1″ NR $24.99 |
|
|
DIA FLO 007-2538-903-00R VALVE DIAPHRAGM GATE 2538 $89.99 |
|
|
VAT Gate Valve – 6 Inch – 12144-PA24-4G71/0879 A-848991 $1,500.00 |
|
|
FAIRBANKS GATE VALVE 1 1/4″ 300 WOG 150-S $27.00 |
|
|
Two Gate Valves – 3″ Red-White – Sweat $40.00 |
|
|
8-Red-White Gate Valves-3/4″ FIP $25.00 |
|
|
Aquasana AQ-4500 Complete Under Counter Water Filter System $143.98 Aquasana’s Under Counter Drinking Water Filter installs in minutes without the need for a plumber! Aquasana’s patented dual cartridge drinking water filter provides up to 30 gallons an hour of ultra-filtered, high-quality water for drinking, cooking and preparing beverages. Replace the filter cartridges every six months with Aquasana AQ-4035 dual cartridge replacement filters. Always have fres… |
|
|
1-1/4 Stainless Steel (316) Gate Valves – ISO 9001, NPT Threaded $71.33 * NPT threaded ends to ANSI B1.20.1… |
|
|
Zoeller 30-0181 Check Valve, 1-1/2 Inch $10.61 … |
|
|
Pneumatic Tire and Wheel – 10.5in. x 4.10/3.50-4 $7.99 Ideal for carts, wheelbarrows, handtrucks and more Nylon reinforced rubber, tube-type tire comes mounted on a steel ball bearing wheel with brass valve stem. Each has a 5/8in. ball bearing hub. 2-piece wheel with sawtooth tread. Item# 1339 is offset (see Item# 1343 for model that is not offset). Tire Type: Pneumatic, Tire Size: 10.5 x 4.10/3.50 x 4, Load Capacity (lbs.): 200, Rim Size (in.): 4… |
|
|
King Brothers Inc. GVP-1000-S 1-Inch Slip PVC Schedule 40 Gate Valve, White $7.49 PVC GATE VALVE – Polypropylene wedge for smooth sealing and longer service (EPDM O’ring). Meets/ exceeds ASTM schedule 40 dimensional and material standards. Strong non-rising stem construction. Made of high impact PVC type II material. Molded in the USA by KBI. Pressure rated to 150 psi @ 73deg.F nominal operating pressure. Listed by IAPMO as meeting the requirements of the Uniform Plumbing Code … |